Canon imageRUNNER ADVANCE C5500 Series Service Manual page 586

602-FF11-00
Detection Description
Remedy
604-0512-00
Detection Description
Remedy
604-1024-00
Detection Description
Remedy
604-1536-00
Detection Description
Remedy
613-0512-00
Detection Description
Remedy
613-1024-00
Detection Description
Remedy
613-1536-00
Detection Description
Remedy
614-0001-00
Detection Description
Remedy
HDD error
An unidentified HDD error was detected after startup.
[Related parts] R1.00
- Main Controller PCB
- HDD
[Remedy] Perform the following in the order while checking whether the error is cleared.
1. Check the related harness/cable and connector.
2. Format the HDD and reinstall the system software using SST or a USB flash drive.
3. Check/replace the related parts.
[Reference] For backup and restoration, refer to "Adjustment> Main Controller System" and
"Appendix> Backup Data List" in the Service Manual.
Faulty/insufficient image memory (Main Controller PCB1)
No necessary memory at Main Controller PCB 1
Make the Memory capacity at Main Controller PCB 1 as indicated by 0512.
Faulty/insufficient image memory (Main Controller PCB1)
No necessary memory at Main Controller PCB 1
Make the Memory capacity at Main Controller PCB 1 as indicated by 1024.
Faulty/insufficient image memory (Main Controller PCB1)
No necessary memory at Main Controller PCB 1
Make the Memory capacity at Main Controller PCB 1 as indicated by 1536.
Faulty/insufficient image memory
No necessary memory at Main Controller PCB
Make the Memory capacity at Main Controller PC as indicated by 0512.
Faulty/insufficient image memory
No necessary memory at Main Controller PCB
Make the Memory capacity at Main Controller PCB as indicated by 1024.
Faulty/insufficient image memory
No necessary memory at Main Controller PCB
Make the Memory capacity at Main Controller PCB as indicated by 1536.
Flash PCB error
The Flash PCB could not be recognized, or the Flash PCB was not formatted.
[Related parts] R1.00
- SATA Flash PCB
- Main Controller PCB
[Remedy] Perform the following in the order while checking whether the error is cleared.
- Reinstall the necessary application software once the error is cleared.
1. After turning OFF the main power, remove and then install the SATA Flash PCB again to check
that it is properly installed.
2. Enter safe mode using (2+8) startup, and execute Flash Format using SST or a USB flash drive.
3. After replacing the SATA Flash PCB, reinstall the system software using SST or a USB flash
drive.
4. Replace the Main Controller PCB.
[Reference] For backup and restoration, refer to "Adjustment> Main Controller System" and
"Appendix> Backup Data List" in the Service Manual.
572
7. Error/Jam/Alarm