Canon imageRUNNER ADVANCE C5500 Series Service Manual page 951

COPIER > OPTION > NETWORK
PRCLTYPE 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
VLAN-SW 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Supplement/Memo
FTPMODE 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
SSLMODE 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Additional Functions
Mode
Setting of dedicated protocol type
To set the type of dedicated protocol (CPCA protocol).
When 1 is set, only the commands where security has been improved are accepted, whereas
conventional commands are rejected.
Upon user's request (for customization)
- Job assignment from Print/Scan/Fax driver at department management
- AiRFAX transmission job assignment
- Setting/changing of system administrator function from a remote utility such as iWEMC
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
With TYPE 1, compatibility with conventional drivers and iW products may be lost.
0 to 1
0: TYPE 0 (Compatible in a conventional manner), 1: TYPE 1
0
ON/OFF VLAN participation packets send
To set whether to send packets for participating in dynamic VLAN at link-up.
When participating in dynamic VLAN
Enter the setting value, and then press OK key.
0 to 1
0: OFF, 1: ON
0
- VLAN (Virtual LAN): A method for realizing grouping of terminals depending on the hub, switch
connection port, MAC address, protocol, etc.
- At link-up: At startup, when LAN cable is connected, when recovering from deep sleep, when
pressing the button to reflect the setting (dynamic update)
- If IP address of the machine has not been set, an IP address is assigned after participating in
VLAN.
Set of FTP print default operation mode
To set the default operation mode of FTP print.
Switch the default operation mode between ASCII mode and BIN mode in accordance with user's
environment.
At installation
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: ASCII mode, 1: BIN mode
0
Setting of HTTP/HTTPS port open/close
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set whether to open or close HTTP/HTTPS port.
When 1 is set while [Use HTTP] is ON and [SSL Settings] is OFF in Settings/Registration menu,
HTTP port is opened whereas HTTPS port is closed.
When 2 is set while both [Use HTTP] and [SSL Settings] are ON in Settings/Registration menu,
HTTP port is closed whereas HTTPS port is opened.
When limiting the port to open because of security concern
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 2
0: Normal, 1: Open HTTP port (80/8000) only, 2: Open HTTPS port (443/8443) only
0
Preferences> Network> TCP/IP Settings> Use HTTP
Management Settings> License/Other> MEAP Settings> SSL Settings
937
8. Service Mode