Removing The Waste Toner Feed Unit - Canon imageRUNNER ADVANCE C5500 Series Service Manual

CAUTION:
If the Developing Unit Seal [1] tears by accident, pull out the end of the torn seal in the direction of the arrow.
Be sure that the torn seal does not remain inside the Developing Unit.
CAUTION:
• To check that the Developing Unit is properly installed, move the Developing Unit toward the front and rear by hand.
If it won't move at all, check again that the Developing Unit is properly installed.
• Be sure not to touch the Developing Cylinder during the work.
CAUTION:
Be careful not to damage the contact point of the drum (on the host machine side) when installing the Developing Unit.
3. Follow "Installing the Drum Unit" to install the Drum Unit of each color.
CAUTION:
Actions after Replacement:"Actions after Parts Replacement" on page 436

Removing the Waste Toner Feed Unit

■ Preparation
1. Pulling out the Process
2. Removing the Drum Unit"Removing the Drum Unit" on page 325
Unit"Pulling out the Process Unit" on page 317
[1]
333
4. Disassembly/Assembly
[1]