Removing the All-night Power Supply PCB
■ Preparation
1. Removing the Rear Lower Cover
2. Removing the AC Driver Unit
1. Disconnect all the connectors from the PCB, and remove the AC Driver Unit [1].
• 6 Wire Saddles [2]
• 10 Connectors [3] (9 for outside Japan)
• 3 Screws [4]
• 2 Hooks [5]
6x
10x
■ Procedure
1. Move the Connector Support Plate [1] so that it does not disturb the work.
• 2 Screws [2]
"Removing the Rear Lower Cover" on page 262
[2]
[2]
[3]
[2]
2x
[3]
[1]
[1]
[2]
274
4. Disassembly/Assembly
3x
[5]
[5]
[4]
[1]