Removing The Riser Pcb - Canon imageRUNNER ADVANCE C5500 Series Service Manual

4. Be sure to remove the parts from the old PCB to the new PCB.
CAUTION:
Do not transfer the following parts to another model (which has a different serial number).
If you fail to do so, the Main Body does not activate normally and this might cause to fail the restoration.
• Flash PCB [1]
TPM PCB [2]
Memory PCB [3]
Bypass PCB [4]
• After replacement of the Main Controller PCB, there is no need to set/register the data again.
CAUTION:
When installing, hold the handle [1], insert the Main Controller PCB [2], check the connection of the Board-to-Board
Connector [3], and secure it with the screw [4].
• 1 Screw
[2]

Removing the Riser PCB

■ Preparation
1. Open the Right Lower Cover and the Right Upper Cover.
2. Removing the Right Rear Cover
3. Removing the Left Rear Cover
[1]
[2]
[4]
[1]
255
4. Disassembly/Assembly
[4]
[3]
[3]
1x
1x