Canon imageRUNNER ADVANCE C5500 Series Service Manual page 1140

3
Securing the Host Machine
1
NOTE:
• Move the main body to the installation position, and
secure it in place by turning the 4 adjusters of the
Cassette Pedestal with a screwdriver.
• Be sure to secure it in place to prevent overturning.
• Securing with the adjusters is not an earthquake
countermeasure.
Turning the Main Power ON /
Setting the Toner Container
CAUTION:
Only for Korea and China, the Toner Container is
installed on the host machine.
1. Connect the power plug of the host machine to the
power outlet.
2. Remove the protection sheet on the control panel.
3. Open the switch cover and turn ON the main power
switch.
NOTE:
• Supply of toner and initialization of the Developing
Assembly and the Drum are automatically performed.
• When toner supply is completed, the operation stops.
(Approx. 2 to 3 minutes)
• Even turning OFF the main power during drum
initialization, developing assembly initialization and
toner fill, they will be re-executed when turning ON
the power again.
NOTE:
Turning OFF the Main Power Switch
1. Turn OFF the main power switch of the host machine.
2. Be sure that Control Panel Display and Main Power
Lamp are both turned OFF, and then disconnect the
power plug.
CAUTION:
• In case of the host machine with the Toner
Container, once the machine goes to standby
state, drum initialization, developing assembly
initialization and toner refill are completed.
• In case of the host machine without the Toner
Container, execute the following procedures.
4. Open the Toner Replacement Cover.
5. Add check marks to each color displayed on the
operation screen, and press [Remove Toner
Cartridges] to open the Small Cover.
1126
9. Installation