Canon imageRUNNER ADVANCE C5500 Series Service Manual page 956

COPIER > OPTION > CLEANING
DRMR-MNG 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Related Service Mode
■ FEED-SW
COPIER > OPTION > FEED-SW
EVLP-SPD 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Related Service Mode
Set additional exe: wrmup rtn,1st pw-on
To set whether to form toner band on the Photosensitive Drum and extend idle rotation time of the
drum at warm-up rotation performed first time for the day.
Set 1 or 2 when image smear occurs. When absolute moisture content is 19.8 g/m3 or more, toner
band is formed and idle rotation of the drum is extended.
Set 3 or 4 when an image failure occurs after replacement of the ITB with a new one. When absolute
moisture content is 19.8 g/m3 or more and the ITB parts counter is less than 50,000 sheets, toner
band is formed and idle rotation of the drum is extended. When the ITB parts counter shows 50,000
sheets or more, the setting is disabled.
Set 5 or 6 to form toner band and extend idle rotation of the drum regardless of usage environment.
- When image smear occurs
- When an image failure occurs after replacement of the ITB
- White lines at intervals of drum circumference (engagement position of the Photosensitive Drum
and the ITB)
- White lines/black lines at intervals of ITB circumference
- When the foregoing image failures are expected to occur (19.8 g/m3 or more of absolute moisture
content)
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
When 1to 6 is set, FCOT becomes longer. Switch the setting according to the usage environment.
0 to 6
0: OFF
1: 30 seconds (Moisture content: 19.8 g/m3 or more)
2: 60 seconds (Moisture content: 19.8 g/m3 or more)
3: 30 seconds (Moisture content: 19.8 g/m3, TR-BLT < 50000)
4: 60 seconds (Moisture content: 19.8 g/m3, TR-BLT < 50000)
5: 30 seconds
6: 60 seconds
0
COPIER> COUNTER> DRBL-1> TR-BLT
Setting of envelope feeding speed
To set the feeding speed of envelope.
By feeding an envelope at 1/2 speed (default) in the case of a high humidity environment, the glue
flap may adhere at the time of fixing. As a result of that, the envelope may not be opened.
When 1/1 speed is set, adhesion can be prevented, but fixing performance is decreased in a low
humidity environment.
When a glue flap of envelope adheres
Enter the setting value, and then press OK key.
When 1 is set in a low humidity environment, fixing performance is decreased.
0 to 1
0: 1/2 speed, 1: 1/1 speed
0
COPIER> OPTION> FEED-SW> EVLP-FS
942
8. Service Mode