Canon imageRUNNER ADVANCE C5500 Series Service Manual page 1095

SORTER > ADJUST
FR-STP-X 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Supplement/Memo
Amount of Change per
Unit
FR-STP-Y 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Supplement/Memo
Amount of Change per
Unit
Adj stpl free stpl pstn (Fd way): Fin-H1
To adjust the staple position for paper feed direction in the staple free stapling mode.
As the value is changed by 1, the staple position moves by 0.1 mm.
+: Toward inlet direction
-: Toward delivery direction
When replacing the Finiser Controller PCB/clearing the RAM data of the Finiser
Controller PCB, enter the value of service label.
When the staple position in paper feed direction is displaced in the staple free stapling mode
When replacing the Finiser Controller PCB/clearing the RAM data of the Finiser Controller PCB.
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
After the setting value is changed, write the changed value in the service label.
-15 to 15
mm
Change the paper shift amount in the paper feed direction. The staple free stapler position is not
changed.
0.1
Adj stpl free stpl pstn (F/R):Fin-H1/Y1
To adjust the staple position for front/rear direction in the staple free stapling mode.
As the value is changed by 1, the staple position moves by 0.1 mm.
+: Toward rear
-: Toward front
When replacing the Finiser Controller PCB/clearing the RAM data of the Finiser
Controller PCB, enter the value of service label.
When the staple position in front/rear direction is displaced in the staple free stapling mode
When replacing the Finiser Controller PCB/clearing the RAM data of the Finiser Controller PCB.
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
After the setting value is changed, write the changed value in the service label.
Fin-H1: -30 to 30
Fin-Y1: -20 to 15
mm
0
Change the paper shift amount in the front/rear direction. The staple free stapler position is not
changed.
0.1
1081
8. Service Mode