Canon imageRUNNER ADVANCE C5500 Series Service Manual page 854

COPIER > ADJUST > HV-PRI
DIS-TGY2 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Related Service Mode
Amount of Change per
Unit
DIS-TGM2 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Related Service Mode
Amount of Change per
Unit
DIS-TGC2 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Related Service Mode
Amount of Change per
Unit
Discharge crrnt ctrl Y tgt crrnt: L-SPD
To adjust the offset of the target current of discharge current control for Y-color at low process
speed.
As the value is changed by 1, the current is changed by 5 micro A.
When an image failure (sand-like image) occurs
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
- Use OFSTACY2 only when an image failure is not alleviated with DIS-TGY2. In such case, be
sure to change the setting value of this item back to the original one. If both the settings are enabled,
an over discharge occurs.
- Do not use this item if adjustment has been made with OFSTACY2 first.
-10 to 10
uA
0
COPIER> ADJUST> HV-PRI> OFSTACY2
5
Discharge crrnt ctrl M tgt crrnt: L-SPD
To adjust the offset of the target current of discharge current control for M-color at low process
speed.
As the value is changed by 1, the current is changed by 5 micro A.
When an image failure (sand-like image) occurs
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
- Use OFSTACM2 only when an image failure is not alleviated with DIS-TGM2. In such case, be
sure to change the setting value of this item back to the original one. If both the settings are enabled,
an over discharge occurs.
- Do not use this item if adjustment has been made with OFSTACM2 first.
-10 to 10
uA
0
COPIER> ADJUST> HV-PRI> OFSTACM2
5
Discharge crrnt ctrl C tgt crrnt: L-SPD
To adjust the offset of the target current of discharge current control for C-color at low process
speed.
As the value is changed by 1, the current is changed by 5 micro A.
When an image failure (sand-like image) occurs
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
- Use OFSTACC2 only when an image failure is not alleviated with DIS-TGC2. In such case, be
sure to change the setting value of this item back to the original one. If both the settings are enabled,
an over discharge occurs.
- Do not use this item if adjustment has been made with OFSTACC2 first.
-10 to 10
uA
0
COPIER> ADJUST> HV-PRI> OFSTACC2
5
840
8. Service Mode