Canon imageRUNNER ADVANCE C5500 Series Service Manual page 1104

SORTER > FUNCTION
CL-CHK 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Related Service Mode
CL-ON 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Related Service Mode
PUN-BK-R 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Related Service Mode
PUN-BK-W 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Related Service Mode
EMSG-CLR 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Specify of operation Clutch: Fin-Y1
To specify the Clutch to operate.
When replacing the Clutch/checking the operation
Enter the value, and then press OK key.
1 to 3
1: Lower stack delivery roller clutch (CL102)
2: Escape feed clutch (CL101)
3: Paddle clutch (CL103)
SORTER> FUNCTION> CL-ON
Operation check of Clutch: Fin-Y1
To start operation check for the Clutch specified by CL-CHK.
After the clutch operates for the specified period of time (10 to 30 seconds), it automatically stops.
When replacing the Clutch/checking the operation
Select the item, and then press OK key.
- When the job starts during the operation of the clutch, the finisher sequence error jam occurs.
- When the error avoidance jam occurs during the operation of the clutch, the jam becomes the
error immediately.
During operation: ACTIVE, At normal termination: OK, At abnormal termination: NG
SORTER> FUNCTION> CL-CHK
Puncher backup data saving: Fin-H1/Y1
To read the backup data from Puncher Controller PCB and save in HDD.
When replacing the Puncher Controller PCB
1) Select the item, and then press OK key.
2) Turn OFF/ON the main power switch.
During operation: ACTIVE, At normal termination: OK, At abnormal termination: NG
SORTER> FUNCTION> PUN-BK-W
Puncher backup data writing: Fin-H1/Y1
To write the backup data saved in HDD to Puncher Controller PCB.
When replacing the Puncher Controller PCB
1) Select the item, and then press OK key.
2) Turn OFF/ON the main power switch.
During operation: ACTIVE, At normal termination: OK, At abnormal termination: NG
SORTER> FUNCTION> PUN-BK-R
Clear Fin limited functions mssg:All Fin
To clear the message related to staple free stapling that is displayed when functions of Finisher
are limited.
The staple free stapling alarm (61-0002) is released.
When clearing the message related to limited functions mode that is displayed after
troubleshooting of finisher is performed
Select the item, and then press OK key.
Only the messages related to staple free stapling can be cleared.
At normal termination: OK, At abnormal termination: NG
1090
8. Service Mode