Canon imageRUNNER ADVANCE C5500 Series Service Manual page 898

COPIER > FUNCTION > PART-CHK
Default Value
Related Service Mode
Supplement/Memo
MTR-ON 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Related Service Mode
SL 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
SL-ON 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Required Time
Related Service Mode
■ CLEAR
COPIER > FUNCTION > CLEAR
ERR 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
45: Deck pickup motor (M1) (Paper Deck Unit)
*1: It does not operate.
*2: The three motors
0
COPIER> FUNCTION> PART-CHK> MTR-ON
Process speed (reference)
iR-ADV C5560 series: 264/222/132 mm/sec
iR-ADV C5550/5540 series: 222/132 mm/sec
iR-ADV C5535 series: 145/132 mm/sec
Operation check of motor
To start operation check of the motor specified by MTR.
After the motor operates for the specified period of time (2 to 30 seconds), it automatically stops.
When replacing the motor/checking the operation
Select the item, and then press OK key.
Check operation of the motor with your eyes and ears. When the specified time has passed after
the DC Controller sent a command, "OK!" is displayed even if the motor does not actually operate
due to connection failure of connector or open circuit.
When an error occurs with the target motor or operation of the machine is not available, "NG" is
displayed.
During operation: ACTIVE, At normal termination: OK!, At failure occurrence: NG
COPIER> FUNCTION> PART-CHK> MTR
Specification of operation solenoid
To specify the solenoid to operate.
When replacing the solenoid/checking the operation
Enter the value, and then press OK key.
1 to 9
1: Registration Shutter Solenoid (SL1), 2 to 4: Not used, 5: First Delivery Flapper Solenoid (SL5),
6: Second Delivery Flapper Solenoid (SL6), 7: Third Delivery Flapper Solenoid (SL7), 8 to 9: Not
used
0
COPIER> FUNCTION> PART-CHK> SL-ON
Operation check of solenoid
To start operation check of the solenoid specified by SL.
The operation stops after "ON for 0.5 sec" => "OFF for 10 sec" => "ON for 0.5 sec" => "OFF for
10 sec" => "ON for 0.5 sec".
When replacing the solenoid/checking the operation
Select the item, and then press OK key.
During operation: ACTIVE, When operation finished normally: OK!
1 min
COPIER> FUNCTION> PART-CHK> SL
Clear of error code
To clear the specific error code.
At error occurrence
1) Select the item, and then press OK key.
2) Turn OFF/ON the main power switch.
During operation: ACTIVE, When operation finished normally: OK!
884
8. Service Mode