Canon imageRUNNER ADVANCE C5500 Series Service Manual page 557

578-8002-02
Detection Description
Remedy
57B-8001-02
Detection Description
Remedy
Error in the Return Roller Lift Motor (Finisher-Y1)
The Return Roller HP Sensor does not detect the return roller when the Return Roller Lift Motor
has been driven for 1 second.
STAPLE FIN-Y1/BOOKLET FIN-Y1
[Related parts]
- Harnesses from the Return Roller HP Sensor (PS121) to the Finisher Controller PCB
- Harnesses from the Return Roller Lift Motor (M111) to the Finisher Controller PCB
- Return Roller HP Sensor (PS121)
- Return Roller Lift Motor (M111)
- Finisher Controller PCB (PCB101)
[Points to note at work] When the Swing Guide Safety Switch (SW102) turns on at the detection
timing of this error, this error code may be displayed. Accordingly, perform the following work before
checking the related parts.
1. Check whether there is not the mulfunction in the swing guide unit.
2. Check whether there is not the mulfunction in the Swing Guide Safety Switch (SW102).
[Points to note at work] When the Swing Guide Safety Switch (SW102) turns on at the detection
timing of this error, this error code may be displayed. Accordingly, perform the following work before
checking the related parts.
1. Check whether there is not the mulfunction in the swing guide unit.
2. Check whether there is not the mulfunction in the Swing Guide Safety Switch (SW102).
[Remedy] Check/replace the related harness/cable, connector and parts.
[Reference] When replacing the Finisher Controller PCB, refer to "Adjustment> When Replacing
the Parts" in the Service Manual.
Error in the Paper End Pushing Guide Motor (Finisher-Y1)
The paper end pushing guide does not come off the Paper End Pushing Guide HP Sensor when
the Paper End Pushing Guide Motor has been driven for 1 second.
STAPLE FIN-Y1/BOOKLET FIN-Y1
[Related parts]
- Harnesses from the Paper End Pushing Guide HP Sensor (PS122) to the Finisher Controller
PCB
- Harnesses from the Paper End Pushing Guide Motor (M112) to the Finisher Controller PCB
- Paper End Pushing Guide HP Sensor (PS122)
- Paper End Pushing Guide Motor (M112)
- Finisher Controller PCB (PCB101)
[Points to note at work] When the Swing Guide Safety Switch (SW102) turns on at the detection
timing of this error, this error code may be displayed. Accordingly, perform the following work before
checking the related parts.
1. Check whether there is not the mulfunction in the swing guide unit.
2. Check whether there is not the mulfunction in the Swing Guide Safety Switch (SW102).
[Remedy] Check/replace the related harness/cable, connector and parts.
[Reference] When replacing the Finisher Controller PCB, refer to "Adjustment> When Replacing
the Parts" in the Service Manual.
543
7. Error/Jam/Alarm