Canon imageRUNNER ADVANCE C5500 Series Service Manual page 865

COPIER > ADJUST > HV-TR
B2TR-LNG 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Amount of Change per
Unit
T2TR-H51 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
T2TR-H52 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
Adj end edg weak bias apply lngth:sgl Bk
To adjust the length (distance from the trailing edge of paper) to apply trailing edge weak bias in
single Bk-color mode.
As the value is changed by 1, it is changed by 0.1 mm.
Increase the value when white spots occur in a broad area of the trailing edge of paper.
When an image failure (white spots at the trailing edge) occurs in single Bk-color mode
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
Use this item only when an image failure occurs.
-50 to 50
0
0.1
Adj of lead edge weak bias: heavy 5, 1st
To adjust the offset of the leading edge weak bias applied to the 1st side of heavy paper 5.
As the value is changed by 1, the bias is changed by 30 V.
Decrease the value if white spots occur.
Increase the value if density on the leading edge of paper is low (transfer is weak).
When an image failure (white spots at the leading edge) occurs
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
Use this item only when an image failure occurs.
-128 to 127
V
0
30V
Adj of lead edge weak bias: heavy 5, 2nd
To adjust the offset of the leading edge weak bias applied to the 2nd side of heavy paper 5.
As the value is changed by 1, the bias is changed by 30 V.
Decrease the value if white spots occur.
Increase the value if density on the leading edge of paper is low (transfer is weak).
When an image failure (white spots at the leading edge) occurs
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
Use this item only when an image failure occurs.
-128 to 127
V
0
30V
851
8. Service Mode