Canon imageRUNNER ADVANCE C5500 Series Service Manual page 803

COPIER > ADJUST > CCD
W-PLT-Y 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Amount of Change per
Unit
W-PLT-Z 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Amount of Change per
Unit
SH-TRGT 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Amount of Change per
Unit
Stdrd White Plt white lvl data (Y) entry
To enter the white level data (Y) for the Standard White Plate.
When replacing the Reader Controller PCB/clearing RAM data, enter the value of service label.
When replacing the Copyboard Glass, enter the value of barcode label which is affixed on the
glass.
- When replacing the Reader Controller PCB/clearing RAM data
- When replacing the Copyboard Glass
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
After the setting value is changed, write the changed value in the service label.
1 to 9999
8735
1
Stdrd White Plt white lvl data (Z) entry
To enter the white level data (Z) for the Standard White Plate.
When replacing the Reader Controller PCB/clearing RAM data, enter the value of service label.
When replacing the Copyboard Glass, enter the value of barcode label which is affixed on the
glass.
- When replacing the Reader Controller PCB/clearing RAM data
- When replacing the Copyboard Glass
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
After the setting value is changed, write the changed value in the service label.
1 to 9999
9418
1
Shading target VL (B&W) entry: Copyboard
To enter the B&W shading target value in copyboard reading mode.
When replacing the Reader Controller PCB, enter the value of service label.
When replacing the Scanner Unit, execute COPIER> FUNCTION> CCD> DF-WLVL3, and write
the value which is automatically set in the service label.
- When replacing the Reader Controller PCB/clearing RAM data
- When replacing the Scanner Unit
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
After the setting value is changed, write the changed value in the service label.
1 to 2047
1126
1
789
8. Service Mode