Canon imageRUNNER ADVANCE C5500 Series Service Manual page 823

COPIER > ADJUST > CCD
DFTBK-B 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Amount of Change per
Unit
DFTBK-R 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Amount of Change per
Unit
DFTBK-BW 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Amount of Change per
Unit
Shading target VL (B) entry: back side
To enter the shading target value of Blue on the back side at DADF reading.
When replacing the Reader Controller PCB, enter the value of service label.
When replacing the Copyboard Glass/Scanner Unit (for back side), execute COPIER>
FUNCTION> CCD> DF-WLVL1, DF-WLVL2 and write the value which is automatically set in the
service label.
- When replacing the Reader Controller PCB/clearing RAM data
- When replacing the Scanner Unit (for back side)
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
700 to 1400
1126
COPIER> FUNCTION> CCD> DF-WLVL1/2
1
Shading target VL (R) entry: back side
To enter the shading target value of Red on the back side at DADF reading.
When replacing the Reader Controller PCB, enter the value of service label.
When replacing the Copyboard Glass/Scanner Unit (for back side), execute COPIER>
FUNCTION> CCD> DF-WLVL1, DF-WLVL2 and write the value which is automatically set in the
service label.
- When replacing the Reader Controller PCB/clearing RAM data
- When replacing the Scanner Unit (for back side)
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
700 to 1400
1156
COPIER> FUNCTION> CCD> DF-WLVL1/2
1
Shading target VL (B&W) entry: back
To enter the B&W shading target value on the back side at DADF reading.
When replacing the Reader Controller PCB, enter the value of service label.
When replacing the Copyboard Glass/Scanner Unit (for back side), execute COPIER>
FUNCTION> CCD> DF-WLVL3, DF-WLVL4 and write the value which is automatically set in the
service label.
- When replacing the Reader Controller PCB/clearing RAM data
- When replacing the Copyboard Glass/Scanner Unit (for back side)
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
700 to 1400
1126
COPIER> FUNCTION> CCD> DF-WLVL3/4
1
809
8. Service Mode