Canon imageRUNNER ADVANCE C5500 Series Service Manual page 547

531-8002-02
Detection Description
Remedy
532-8001-02
Detection Description
Remedy
a. Stapler Motor error (Finisher-H1) b. Error in the Staple Motor (Finisher-Y1)
a. The Staple HP Sensor was not turned ON although 0.4 seconds had passed after the Stapler
Motor operation started.
b. The Staple HP Sensor does nor detect the staple unit when the Staple Motor has been driven
for 0.4 seconds.
a. INNER FIN-H1
[Related parts]
- Harnesses and connectors from the Finisher Controller PCB to the Stapler Unit
- Stapler Unit (including the Stapler Motor and the Staple HP Sensor)
- Finisher Controller PCB (PCB1)
b.STAPLE FIN-Y1/BOOKLET FIN-Y1
[Related parts]
- Harnesses from the Stapler Unit to the Stapler Relay PCB
- Harnesses from the Stapler Unit Relay PCB to the Finisher Controller PCB
- Stapler Unit
- Stapler Unit Relay PCB (PCB102)
- Finisher Controller PCB (PCB101)
[Points to note at work] When the Swing Guide Safety Switch (SW102) turns on at the detection
timing of this error, this error code may be displayed. Accordingly, perform the following work before
checking the related parts.
1. Check whether there is not the mulfunction in the swing guide unit.
2. Check whether there is not the mulfunction in the Swing Guide Safety Switch (SW102).
[Remedy] Check/replace the related harness/cable, connector and parts.
[Reference] When replacing the Finisher Controller PCB, refer to "Adjustment> When Replacing
the Parts" in the Service Manual.
a. Stapler Shift Motor error (Finisher-H1) b. Error in the Stapler Shift Motor (Finisher-Y1)
a. The Stapler Shift HP Sensor was not turned OFF although 1 second had passed after the Stapler
Shift Motor operation started.
b. The stapler unit does not come off the Stapler Shift HP Sensor when the Stapler Shift Motor has
been driven for 1 second.
a. INNER FIN-H1
[Related parts]
- Harnesses and connectors from the Finisher Controller PCB to the Stapler Shift HP Sensor
- Harnesses and connectors from the Finisher Controller PCB to the Stapler Shift Motor
- Stapler Shift HP Sensor (PS11)
- Stapler Shift Motor (M7)
- Finisher Controller PCB (PCB1)
b.STAPLE FIN-Y1/BOOKLET FIN-Y1
[Related parts]
- Harnesses from the Stapler Shift HP Sensor (PS124) to the Finisher Controller PCB
- Harnesses from the Stapler Shift Motor (M114) to the Finisher Controller PCB
- Stapler Shift HP Sensor (PS124)
- Stapler Shift Motor (M114)
- Finisher Controller PCB (PCB101)
[Remedy] Check/replace the related harness/cable, connector and parts.
[Reference] When replacing the Finisher Controller PCB, refer to "Adjustment> When Replacing
the Parts" in the Service Manual.
533
7. Error/Jam/Alarm