Canon imageRUNNER ADVANCE C5500 Series Service Manual page 551

7. Error/Jam/Alarm
540-8001-02 a. Tray Shift Motor error (Finisher-H1) b. Stack tray time out error (Finisher-Y1)
Detection Description a. The Stack Tray Paper Height Sensor was not turned ON although 5 seconds had passed after
the Tray Shift Motor operation started.
b. The operation of the stack tray don't finish when the Stack Tray Shift Motor has been driven for
28 seconds.
The stack tray does not come off the same area when the Stack Tray Shift Motor has been driven
for 15 seconds.
Remedy a. INNER FIN-H1
[Related parts]
- Harnesses and connectors from the Finisher Controller PCB to the Stack Tray Paper Height
Sensor
- Harnesses and connectors from the Finisher Controller PCB to the Tray Shift Motor
- Stack Tray Paper Height Sensor (PS9)
- Tray Shift Motor (M6)
- Finisher Controller PCB (PCB1)
b.STAPLE FIN-Y1/BOOKLET FIN-Y1
[Related parts]
- Harnesses from the Stack Tray HP Sensor (PS106) to the Finisher Controller PCB
- Harnesses from the Stack Tray Full Sensor 1/2/3 (PS107/PS108/PS109) to the Finisher
Controller PCB
- Harnesses from the Stack Tray Upper Limit Sensor (PS110) to the Finisher Controller PCB
- Harnesses from the Stack Tray Shift Motor (M105) to the Finisher Controller PCB
- Stack Tray HP Sensor (PS106)
- Stack Tray Full Sensor 1/2/3 (PS107/PS108/PS109)
- Stack Tray Shift Motor (M105)
- Finisher Controller PCB (PCB101)
[Points to note at work] When the Swing Guide Safety Switch (SW102) turns on at the detection
timing of this error, this error code may be displayed. Accordingly, perform the following work before
checking the related parts.
1. Check whether there is not the mulfunction in the swing guide unit.
2. Check whether there is not the mulfunction in the Swing Guide Safety Switch (SW102).
[Remedy] Check/replace the related harness/cable, connector and parts.
[Reference] When replacing the Finisher Controller PCB, refer to "Adjustment> When Replacing
the Parts" in the Service Manual.
537