Canon imageRUNNER ADVANCE C5500 Series Service Manual page 1154

Hide thumbs Also See for imageRUNNER ADVANCE C5500 Series:
Table of Contents

Advertisement

<In case the Cassette1 is Nonstandard>
2. Select the following in Service Mode (Level 1) :
COPIER > ADJUST > FEED-ADJ > REG-DUP1
3. Change the setting value to make adjustment (1
increment of the setting value reduces the lead-edge
margin by 0.1mm)
4. To make the setting value effective, turn OFF/ON the
main power of the Host Machine.
5. Write down the new adjustment value on the service
label.
• REG-DUP1
Checking Network Connection
■ Overview
If the user network environment is TCP/IP, use Ping function
to check that the network setting is properly executed.
If the user network environment is IPX/SPX or Apple Talk,
skip this procedure.
■ Checking Network Connection
CAUTION:
Use the network cable of rank 5e or higher. In addition,
use of shield type (STP cable) is recommended.
When non-shield type (UTP cable) is used, the
surrounding electronic equipments may be interfered
via the network cable.
1. Turn OFF the main power switch.
2. Connect the network cable to the host machine and
turn ON the main power switch.
3. Inform the system administrator at the installation
site that the installation of the host machine is
complete, and ask for network connection of the
host machine.
NOTE:
Network setting cannot be executed unless logging in as
an administrator.
Factory default password is as follows.
• System administration division ID: Administrator
• System administration password: 7654321
CAUTION:
Following setting needs to be ON to perform network
setting:
• [Settings/Registration] > [Preferences] >
[Network] > [Confirm Network Connection Set.
Changes]
• [Settings/Registration] > [Preferences] >
[Network] > [TCP/IP Settings] > [IPv4 Settings] >
[Use IPv4]
4. Turn OFF the main power switch.
5. Turn ON the main power switch.
■ Ping Operation Procedure
1. Select [Settings/Registration] > [Preferences] >
[Network] > [TCP/IP Settings] > [IPv4 Settings] >
[PING Command].
2. Enter IP address with numeric keypad on the control
panel and press "Start" key. "Response from the
host" is displayed if Ping operation is successful.
"No response from the host" is displayed if Ping
operation fails.
■ Checking with Remote Host
Address
You can check whether the network is connected or not by
using remote host address to execute Ping.
Remote host address: IP address of PC terminal that is
connected to/works with TCP/IP network environment, which
connects to this host machine.
1. Inform the system administrator to execute
checking of network connection using Ping.
2. Check the remote host address with the system
administrator.
3. Enter the remote host address to PING.
• "Response from the host": The machine is properly
connected to the network.
• "No response from the host": Execute the following
troubleshooting because the machine is not
connected to the network.
1140
9. Installation

Advertisement

Table of Contents
loading

Table of Contents