Canon imageRUNNER ADVANCE C5500 Series Service Manual page 862

COPIER > ADJUST > HV-TR
1TR-TGC2 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Related Service Mode
1TR-TK12 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Related Service Mode
1TR-TGY3 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Related Service Mode
Adj C-clr pry trns ATVC tgt crrnt: L-SPD
To adjust the target current of primary transfer ATVC control for C-color at low process speed.
Increase the value when low-voltage mottled image occurs, and decrease the value when fogging
occurs (especially in the 95 mm portion of the image leading edge).
By setting this item, primary transfer ATVC control is automatically executed during initial rotation
for next image formation and the setting value is reflected.
When an image failure due to the primary transfer occurs
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Execute 1ATVC-EX.
-50 to 50
uA
0
COPIER> FUNCTION> MISC-P> 1ATVC-EX
Adj sgl Bk pry trns ATVC tgt crrnt:L-SPD
To adjust the target current of primary transfer ATVC control for Bk-color at low process speed in
black mode.
Increase the value when low-voltage mottled image occurs, and decrease the value when fogging
occurs (especially in the 95 mm portion of the image leading edge).
By setting this item, primary transfer ATVC control is automatically executed during initial rotation
for next image formation and the setting value is reflected.
When an image failure due to the primary transfer occurs in black mode
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Execute 1ATVC-EX.
-50 to 50
uA
0
COPIER> FUNCTION> MISC-P> 1ATVC-EX
Adj Y-clr pry trns ATVC tgt crrnt: M-SPD
To adjust the target current of primary transfer ATVC control for Y-color at middle process speed.
Increase the value when low-voltage mottled image occurs, and decrease the value when fogging
occurs (especially in the 95 mm portion of the image leading edge).
By setting this item, primary transfer ATVC control is automatically executed during initial rotation
for next image formation and the setting value is reflected.
When an image failure due to the primary transfer occurs
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Execute 1ATVC-EX.
This item is enabled only when using heavy paper 1 (106 to 128 g/m2) with 60 ppm machine.
-50 to 50
uA
0
COPIER> FUNCTION> MISC-P> 1ATVC-EX
848
8. Service Mode