Canon imageRUNNER ADVANCE C5500 Series Service Manual page 852

COPIER > ADJUST > COLOR
PH-OFS-K 2
Detail
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Additional Functions
Mode
Supplement/Memo
■ HV-PRI
COPIER > ADJUST > HV-PRI
DIS-TGY 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Related Service Mode
Amount of Change per
Unit
Adj Bk-clr hi dens area clr balance: PDL
To adjust the color balance of the high density area of Bk-color at PDL print.
As the value is larger, the image gets darker.
In case of data generated by the printer driver and stored in Mail Box, a value obtained by adding
the value adjusted in [Fine Adjust Density] in [Access Stored Files] to the setting value of this item
is applied as the actual density value.
e.g.: When the value of this item is "-4" and the value of [Fine Adjust Density] is "5", the density
value is "1".
Note that the density value must be within the rage from -8 to 8.
e.g.: When the value of this item is "7" and the value of [Fine Adjust Density] is "5", the density
value is "8".
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
-8 to 8
0
Copy> Options> Color Balance> Fine Adjust Density
Access Stored Files> Mail Box> Print> Change Print Settings> Options> Color Balance> Fine
Adjust Density
Adjustment/Maintenance> Adjust Image Quality> Color Balance> Non-Coated> Fine Adjust
Density
Adjustment/Maintenance> Adjust Image Quality> Color Balance> Coated> Fine Adjust Density
In [Fine Adjust Density] in [Adjustment/Maintenance], the same value is set as the density for copy
operation and file storage.
In [Fine Adjust Density] under [Copy] and [Access Stored Files] in the main menu, the density value
can be set individually. Although the setting value of this item is just one value, the density may
differ for copy operation and file storage.
Discharge crrnt ctrl Y tgt crrnt: H-SPD
To adjust the offset of the target current of discharge current control for Y-color at high process
speed.
As the value is changed by 1, the current is changed by 5 micro A.
When an image failure (sand-like image) occurs
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
- Use OFSTAC-Y only when an image failure is not alleviated with DIS-TGY. In such case, be sure
to change the setting value of this item back to the original one. If both the settings are enabled,
an over discharge occurs.
- Do not use this item if adjustment has been made with OFSTAC-Y first.
-10 to 10
uA
0
COPIER> ADJUST> HV-PRI> OFSTAC-Y
5
838
8. Service Mode