Canon imageRUNNER ADVANCE C5500 Series Service Manual page 947

COPIER > OPTION > NETWORK
IKERETRY 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Supplement/Memo
SPDALDEL 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Supplement/Memo
NCONF-SW 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Supplement/Memo
IKEINTVL 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Supplement/Memo
Amount of Change per
Unit
IPSDEBLV 2
Setting of IKE retry times
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set the number of retries in the case of no response from the communication target at the time
of IKE packet transmission.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 3
time
1
IKE: Internet Key Exchange
Initialization of SPD value
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To initialize all the SPD values that are under management.
SPD values can be initialized without clearing SRAM.
At the time of SPD value mismatch when IPSec Board is added
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: OFF, 1: ON
0
SPD: Database that manages SA (Security Association).
SPD value is managed when IPSec Board is used. Normally, SRAM needs to be cleared in the
case of mismatch in SPD value.
ON/OFF of Network Configurator function
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set ON/OFF of Network Configurator function.
If the user does not use the function, select OFF to prevent remote attack through network.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: OFF, 1: ON
1
Network Configurator function is a function to be used for communication with NetSpot Device
Installer, etc., and the network setting can be changed from the remote.
Setting of IKE retry interval
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set retry interval in the case of no response from the communication target at the time of IKE
packet transmission.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
1 to 10
sec
5
IKE: Internet Key Exchange
1
For R&D
933
8. Service Mode