Canon imageRUNNER ADVANCE C5500 Series Service Manual page 812

COPIER > ADJUST > CCD
DFCH2G10 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Amount of Change per
Unit
MTF-M1 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Amount of Change per
Unit
MTF-M2 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Amount of Change per
Unit
MTF-M3 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Amount of Change per
Unit
Complex chart No.10 data (G) entry:front
To derive the front/back side linearity, enter the Green data on the front side of No.10 image in
DADF complex chart.
Enter the value of service label on the Reader.
When replacing the Reader Controller PCB/clearing RAM data
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 2550
0
1
MTF value 1 entry: horz scan, back side
To enter the setting value 1 for MTF filter coefficient calculation in horizontal scanning direction.
Enter the value of service label on the Reader.
- When replacing the Scanner Unit
- When replacing the Reader Controller PCB/clearing RAM data
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
20 to 85
50
COPIER> FUNCTION> CCD> MTF-CLC
1
MTF value 2 entry: horz scan, back side
To enter the setting value 2 for MTF filter coefficient calculation in horizontal scanning direction.
Enter the value of service label on the Reader.
- When replacing the Scanner Unit
- When replacing the Reader Controller PCB/clearing RAM data
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
20 to 85
50
COPIER> FUNCTION> CCD> MTF-CLC
1
MTF value 3 entry: horz scan, back side
To enter the setting value 3 for MTF filter coefficient calculation in horizontal scanning direction.
Enter the value of service label on the Reader.
- When replacing the Scanner Unit
- When replacing the Reader Controller PCB/clearing RAM data
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
20 to 85
50
COPIER> FUNCTION> CCD> MTF-CLC
1
798
8. Service Mode