Canon imageRUNNER ADVANCE C5500 Series Service Manual page 931

COPIER > OPTION > FNC-SW
1TRDELAY 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
T-DLV2CL 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
TRYFLOFF 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
ON/OFF of image formation timing delay
To set whether to delay the image formation timing when density at image leading edge is low.
Image writing starts while the potential of the Photosensitive Drum is still unstable, density at image
leading edge may become low.
When 1 is set, the timing to start image writing is delayed so the image quality is improved.
However, time required for preprocessing is increased for each job so that productivity is
decreased.
When low leading edge density occurs
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
When 1 is set, productivity for each job is decrease.
0 to 1
0: OFF, 1: ON
0
YMC Tonr Cont (Small) prior dvry alm tmg
To set the toner level as the timing to notify the prior delivery alarm for the Y/M/C-color Toner
Container (Small).
When changing the timing to notify the end of life according to the usage status
Enter the setting value, and then press OK key.
0 to 40
%
12
1
ON/OFF of full detection
To set whether to perform full detection.
When a finisher is disconnected from the host machine, full detection becomes unavailable so
operation of the machine is disabled.
If there is full detection flag which has been removed from the host machine at installation of a
finisher, reinstall it so the operation of the host machine alone becomes available.
If there is no full detection flag, set 1 for this item to disable the full detection so the operation of
the host machine becomes available.
When temporarily operating the host machine without a finisher due to failure/repair
Enter the setting value, and then press OK key.
- When 1 is set, stacking failure or paper jam may occur.
- Be sure to change the value back to 0 after connecting the disconnected finisher again.
0 to 1
0: ON (Normal), 1: OFF
0
917
8. Service Mode