Canon imageRUNNER ADVANCE C5500 Series Service Manual page 816

COPIER > ADJUST > CCD
MTF-S7 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Amount of Change per
Unit
MTF-S8 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Amount of Change per
Unit
MTF-S9 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Amount of Change per
Unit
DFCH-R2 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Amount of Change per
Unit
MTF value 7 entry: vert scan, back side
To enter the setting value 7 for MTF filter coefficient calculation in vertical scanning direction.
Enter the value of service label on the Reader.
- When replacing the Scanner Unit
- When replacing the Reader Controller PCB/clearing RAM data
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
20 to 85
50
COPIER> FUNCTION> CCD> MTF-CLC
1
MTF value 8 entry: vert scan, back side
To enter the setting value 8 for MTF filter coefficient calculation in vertical scanning direction.
Enter the value of service label on the Reader.
- When replacing the Scanner Unit
- When replacing the Reader Controller PCB/clearing RAM data
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
20 to 85
50
COPIER> FUNCTION> CCD> MTF-CLC
1
MTF value 9 entry: vert scan, back side
To enter the setting value 9 for MTF filter coefficient calculation in vertical scanning direction.
Enter the value of service label on the Reader.
- When replacing the Scanner Unit
- When replacing the Reader Controller PCB/clearing RAM data
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
20 to 85
50
COPIER> FUNCTION> CCD> MTF-CLC
1
Complex chart No.2 data (R) entry: back
To derive the front/back side linearity, enter the Red data on the back side of No.2 image in DADF
complex chart.
Enter the value of service label on the Reader.
When replacing the Reader Controller PCB/clearing RAM data
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
1 to 2550
2000
1
802
8. Service Mode