Canon imageRUNNER ADVANCE C5500 Series Service Manual page 1099

SORTER > ADJUST
SDL-FLD2 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Related Service Mode
Supplement/Memo
Amount of Change per
Unit
ESC1-SPD 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Amount of Change per
Unit
SFT-SPD 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Related Service Mode
Amount of Change per
Unit
Adj of Saddle Sttch fold pstn: Fin-Y1
To adjust the fold position of Saddle Stitcher (when using the thin paper; the paper that the paper
weight is less than 64 g/m2).
As the value is incremented by 1, the fold position moves by 0.1 mm.
+: The fold position moves toward the left at open page of the book
-: The fold position moves toward the right at open page of the book
When the fold position of the Saddle Stitcher is displaced with the thin paper
Enter the setting value, and then press OK key.
-20 to 20
mm
SORTER> ADJUST> SDL-FLD
Perform this adjustment after performing the adjustment of SDL-FLD.
Because the fold position of the thin paper is adjusted by the total setting values of SDL-FLD and
SDL-FLD2, the actual adjustment of the fold position is performed in the fold position adjustable
range (-20 to 20) even if entering the setting value beyond the mechanical fold position adjustable
range.
0.1
Adj Escape Tr delivery speed: Fin-Y1
To adjust the delivery speed to the escape tray.
As the value is changed by 1, the delivery speed to the lower escape tray changes by 10 mm/sec.
When the paper stacking to the escape tray is misalignment
Enter the setting value, and then press OK key.
-10 to 0
mm/s
10
Adj dvry speed at collate mode: Fin-Y1
To adjust the delivery speed to the stack tray at collate mode.
As the value is changed by 1, the delivery speed changes by 10 mm/sec.
When the paper stacking of stack tray at collate mode is misalignment
Enter the setting value, and then press OK key.
- When the value is decreased, the productivity is decreased.
- When the buffer operation is performed, delivery speed does not change. (The buffer operation
is the operation to deliver the stacking paper on the processing tray.)
The ON/OFF of buffer operation is set by BUFF-SW.
-5 to 5
mm/s
SORTER> OPTION> BUFF-SW
10
1085
8. Service Mode