Canon imageRUNNER ADVANCE C5500 Series Service Manual page 874

COPIER > ADJUST > FEED-ADJ
LP-FEED1 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
LP-MULT1 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
LP-DUP1 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
REG-SPD 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
Adj pre-rgst arch amount: plain, Casstt
To adjust the arch amount before registration for plain paper fed from a cassette.
As the value is changed by 1, the arch amount is changed by 0.1 mm.
+: Increase
-: Decrease
When an image on the 1st side of plain paper fed from a cassette is skewed
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
-50 to 50
mm
0
0.1
Adj pre-rgst arch amount: plain, MP Tray
To adjust the arch amount before registration for plain paper fed from the Multi-purpose Tray.
As the value is changed by 1, the arch amount is changed by 0.1 mm.
+: Increase
-: Decrease
When an image on the 1st side of plain paper fed from the Multi-purpose Tray is skewed
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
-50 to 50
mm
0
0.1
Adj pre-rgst arch amount: plain, 2-sided
To adjust the arch amount before registration for plain paper fed in 2-sided mode.
As the value is changed by 1, the arch amount is changed by 0.1 mm.
+: Increase
-: Decrease
When an image on the 2nd side of plain paper fed in 2-sided mode is skewed
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
-50 to 50
mm
0
0.1
Adjustment of Registration Motor speed
To adjust the speed of the Registration Motor.
As the value is changed by 1, the speed is changed by 0.2%.
+: Increase
-: Decrease
As the value is reduced, blur image in the area of 40 to 45 mm from the trailing edge is alleviated.
When blur image occurs in the area of 40 to 45 mm from the trailing edge
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
-5 to 5
%
0
0.2
860
8. Service Mode