Canon imageRUNNER ADVANCE C5500 Series Service Manual page 981

COPIER > OPTION > IMG-FIX
FXS-TM11 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
PLN-LP 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
TRC-LP 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Set ITOP control temp: recycled paper 1
To set the offset of ITOP control temperature for recycled paper 1 (64 to 75 g/m2).
As the value is changed by 1, the control temperature is changed by 5 deg C.
Increase the value when a fixing failure occurs on the leading edge of paper, and decrease the
value when uneven gloss occurs on the leading edge (94 mm).
- When a fixing failure occurs on the leading edge of paper
- When uneven gloss occurs on the leading edge (94 mm)
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
-3 to 2
-3: -15 deg C, -2: -10 deg C, -1: -5 deg C, 0: 0 deg C, 1: +5 deg C, 2: +10 deg C
deg C
0
5
Set of fixing arch amount: plain/colored
To set the arch amount between secondary transfer and fixing when feeding plain paper 1 to 3
and colored paper.
Usually, in case of plain paper/colored paper, fixing arch control is performed to make the arch
small.
Set 1 when an image failure (crepe marks) occurs. The arch becomes large when feeding plain
paper/colored paper.
Set 2 or 3 if paper length (in feed direction) causes the image failure.
When an image failure (crepe marks) occurs with plain paper/colored paper
Enter the setting value, and then press OK key.
0 to 3
0: Small arch
1: Large arch
2: Small arch for paper whose length is 220.0 mm or less, large arch for paper whose length
exceeds 220.0 mm
3: Large arch for paper whose length is 220.0 mm or less, small arch for paper whose length
exceeds 220.0 mm
0
Set of fixing arch amount: tracing paper
To set the arch amount between secondary transfer and fixing when feeding tracing paper.
Usually, in case of tracing paper, fixing arch control is performed to make the arch small.
Set 1 when an image failure (crepe marks) occurs. The arch becomes large when feeding tracing
paper.
Set 2 or 3 if paper length (in feed direction) causes the image failure.
When an image failure (crepe marks) occurs with tracing paper
Enter the setting value, and then press OK key.
0 to 3
0: Small arch
1: Large arch
2: Small arch for paper whose length is 220.0 mm or less, large arch for paper whose length
exceeds 220.0 mm
3: Large arch for paper whose length is 220.0 mm or less, small arch for paper whose length
exceeds 220.0 mm
0
967
8. Service Mode