Actions at Parts Replacement
MP Pickup Tray Unit
■ Actions after Parts Replacement
1. Remove the Wire Cover [1] on the rear side of the MP Pickup Tray Unit [1].
• 1 Hook [2]
2. Enter the values shown on the label on the rear side of the MP Pickup Tray Unit in service mode.
• Service mode > COPIER > ADJUST > CST-ADJ > MF-A4
• Service mode > COPIER > ADJUST > CST-ADJ > MF-A5R
• Service mode > COPIER > ADJUST > CST-ADJ > MF-A4R
• Service mode > COPIER > ADJUST > CST-ADJ > MF-MAX
• Service mode > COPIER > ADJUST > CST-ADJ > MF-MIN
3. Install the Wire Cover removed in step 1.
4. Write down the service mode values entered in step 2 on the service label.
DC Controller PCB
How to Replace the
Parts:"Removing the DC Controller PCB" on page 259
■ Processing before replacing the parts
CAUTION:
When replacing the DC Controller PCB, be sure to use a new one. Do not use the DC Controller PCB which was used with
another machine.
[2]
428
5. Adjustment
[1]