Canon imageRUNNER ADVANCE C5500 Series Service Manual page 1101

SORTER > FUNCTION
FN-SENS2 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
FIN-BK-R 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Related Service Mode
FIN-BK-W 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Related Service Mode
FIN-CON 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Related Service Mode
Adj Punch Waste Full Sensor: Fin-H1/Y1
To automatically adjust the output of Punch Waste Full Sensor (Punch Waste Full Detection PCB)
of the Puncher Unit.
- When installing/replacing the Puncher Unit
- When replacing the Punch Waste Full Sensor
Select the item, and then press OK key.
When the sheet of paper is on the sensor, the adjustment fails.
During operation: ACTIVE, At normal termination: OK, At abnormal termination: NG
Finisher backup data saving: Fin-H1/Y1
The backup data is read from the finisher controller PCB and saved to HDD.
When replacing the Finisher Controller PCB
1) Select the item, and then press OK key.
2) Turn OFF/ON the main power switch.
During operation: ACTIVE, At normal termination: OK, At abnormal termination: NG
SORTER> FUNCTION> FIN-BK-W
Writing of Fin backup data: Fin-H1/Y1
The backup data saved in HDD is written to the finisher controller PCB.
When replacing the Finisher Controller PCB
1) Select the item, and then press OK key.
2) Turn OFF/ON the main power switch.
During operation: ACTIVE, At normal termination: OK, At abnormal termination: NG
SORTER> FUNCTION> FIN-BK-R
FIN-Controller PCB RAM clear: Fin-H1/Y1
To execute the RAM clear of Finisher Controller PCB to delete all the adjustment contents. (except
the counter information)
When clearing RAM data of the Finisher Controller PCB
1) Select the item, and then press OK key.
2) Turn OFF/ON the main power switch.
- Output the service mode setting values by P-PRINT before execution. After execution, enter the
necessary setting values.
- RAM clear is executed after the main power is turned OFF/ON.
During operation: ACTIVE, At normal termination: OK, At abnormal termination: NG
COPIER> FUNCTION> MISC-P> P-PRINT
1087
8. Service Mode