Canon imageRUNNER ADVANCE C5500 Series Service Manual page 858

COPIER > ADJUST > HV-PRI
OFSTACM2 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Related Service Mode
Amount of Change per
Unit
OFSTACC2 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Related Service Mode
Amount of Change per
Unit
Adj M-color charging AC voltage: L-SPD
To adjust the offset of the charging AC voltage for M-color at low process speed.
The setting is applied to paper which paper weight is 129 g/m2 or more and coated paper.
As the value is changed by 1, the voltage is changed by 20 Vpp.
Decrease the value when image smear occurs, and increase the value when an image failure
(sand-like image) occurs.
- When image smear occurs
- When an image failure (sand-like image) occurs
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
Use OFSTACM2 only when an image failure is not alleviated with DIS-TGM2. In such case, be
sure to change the setting value of DIS-TGM2 back to the original one. If both the settings are
enabled, an over discharge occurs.
-20 to 20
V
0
COPIER> ADJUST> HV-PRI> DIS-TGM2
20
Adj C-color charging AC voltage: L-SPD
To adjust the offset of the charging AC voltage for C-color at low process speed.
The setting is applied to paper which paper weight is 129 g/m2 or more and coated paper.
As the value is changed by 1, the voltage is changed by 20 Vpp.
Decrease the value when image smear occurs, and increase the value when an image failure
(sand-like image) occurs.
- When image smear occurs
- When an image failure (sand-like image) occurs
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
Use OFSTACC2 only when an image failure is not alleviated with DIS-TGC2. In such case, be
sure to change the setting value of DIS-TGC2 back to the original one. If both the settings are
enabled, an over discharge occurs.
-20 to 20
V
0
COPIER> ADJUST> HV-PRI> DIS-TGC2
20
844
8. Service Mode