Adjust - Canon imageRUNNER ADVANCE C5500 Series Service Manual

ADJUST

■ ADJ-XY
COPIER > ADJUST > ADJ-XY
ADJ-X 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
ADJ-Y 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
Adj start pstn in book mode: vert scan
To adjust the image reading start position (image leading edge position) in the vertical scanning
direction at copyboard reading.
When replacing the Reader Controller PCB/clearing RAM data, enter the value of service label.
Decrease the value when the non-image width is larger than the standard value.
Increase the value when out of original area is copied.
As the value is incremented by 1, the image position is moved to the trailing edge side by 0.1 mm.
When replacing the Reader Controller PCB/clearing RAM data
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
-50 to 50
mm
0
0.1
Adj start pstn in book mode: horz scan
To adjust the image reading start position in the horizontal scanning direction at copyboard reading.
When replacing the Reader Controller PCB/clearing RAM data, enter the value of service label.
Decrease the value when the non-image width is larger than the standard value.
Increase the value when out of original area is copied.
As the value is incremented by 1, the image position is moved to the rear side by 0.1 mm.
When replacing the Reader Controller PCB/clearing RAM data
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
After the setting value is changed, write the changed value in the service label.
-35 to 35
mm
0
0.1
786
8. Service Mode