Canon imageRUNNER ADVANCE C5500 Series Service Manual page 805

COPIER > ADJUST > CCD
DFTAR-G 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Amount of Change per
Unit
DFTAR-B 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Amount of Change per
Unit
MTF2-M1 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Amount of Change per
Unit
Shading target VL (G) entry: front side
To enter the shading target value of Green on the front side at DADF reading.
When replacing the Reader Controller PCB, enter the value of service label.
When replacing the Copyboard Glass/Scanner Unit (for front side), execute COPIER>
FUNCTION> CCD> DF-WLVL1, DF-WLVL2 and write the value which is automatically set in the
service label.
- When replacing the Reader Controller PCB/clearing RAM data
- When replacing the Copyboard Glass/Scanner Unit (for front side)
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
1 to 2047
1189
COPIER> FUNCTION> CCD> DF-WLVL1/2
1
Shading target VL (B) entry: front side
To enter the shading target value of Blue on the front side at DADF reading.
When replacing the Reader Controller PCB, enter the value of service label.
When replacing the Copyboard Glass/Scanner Unit (for front side), execute COPIER>
FUNCTION> CCD> DF-WLVL1, DF-WLVL2 and write the value which is automatically set in the
service label.
- When replacing the Reader Controller PCB/clearing RAM data
- When replacing the Copyboard Glass/Scanner Unit (for front side)
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
1 to 2047
1209
COPIER> FUNCTION> CCD> DF-WLVL1/2
1
MTF value 1 entry: horz scan, front side
To enter the setting value 1 for MTF filter coefficient calculation in horizontal scanning direction.
Enter the value of service label on the Reader.
- When replacing the Scanner Unit
- When replacing the Reader Controller PCB/clearing RAM data
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
20 to 85
50
COPIER> FUNCTION> CCD> MTF-CLC
1
791
8. Service Mode