Canon imageRUNNER ADVANCE C5500 Series Service Manual page 1150

• <When the values are above +350>
Rotate the ITB Motor Support Plate clockwise.
3x
• <When the values are below -350>
Rotate the ITB Motor Support Plate
counterclockwise.
3x
6. Tighten 3 screws loosened on the previous step.
7. Install the ITB Motor. (4 Screws, 1 Connector)
8. Install the ITB Cover (2 screws) and close the Front
Cover.
9. Connect the power plug of the host machine to the
power outlet.
10. Open the switch cover and turn ON the main power
switch.
11. Execute the ITB Equilibrium Position Detection.
Approx. 3 to 4minutes
• Service Mode (Level 1) > COPIER > FUNCTION >
MISC-P > ITB-INIT
12. Check that the value of the following service mode
(Level 1) is "-350 to +350".
• Service Mode (Level 1) > COPIER > DISPLAY >
MISC > ITB-POS
• Service Mode (Level 1) > COPIER > DISPLAY >
MISC > ITB-POS2
13. If the value of service mode is out of range, perform
the [ITB Alignment Adjustment] again.
Adjusting Image Position
NOTE:
• The second side of the 2-sided copy mentioned later
means the second side in the image formation order.
• With this equipment, the second side in the image
formation order at the time of 2-sided copy/print is
equivalent to the first side of the original.
■ Cassette Left Edge Margin
Adjustment(1st;Software
Adjustment)
1. Make 2-sided copies using the Cassette 1 and check
that the left edge margin is 2.5 +/- 1.5 mm.
Feeding direction
of paper
<In case the Cassette1 is Nonstandard>
2. If the left margin is out of the specification, change
the adjustment value for the left margin on the 1st
side in cassettte 1.
As making the following selection: Service Mode
(level1)> COPIER > ADJUST > FEED-ADJ > ADJ-C1
andset 1 value larger, the left edge margin becomes
0.1mm larger.
1136
9. Installation
image