Setting the Environment
Heater Switch
CAUTION:
If the installation environment is a high humidity
environment (*) or low humidity environment (*2), be
sure to turn ON the Environment Heater Switch.
Image smear is likely to occur in the high humidity
environment and charging failure is likely to occur in the
low humidity environment.
* This is the case that the value of the absolute water
volume outside of the machine is about 12g or more.
Service Mode (Level1) > COPIER > DISPLAY >
ANALOG > ABS-HUM
*2The temperature inside the machine is below 15 deg
C.
Service Mode (Level1) > COPIER > DISPLAY >
ANALOG > TEMP2
1
2
CAUTION:
When removing the cover, do not insert a screwdriver
in the oval hole.
Installing IC Card Reader (EUR
Only)
1
1117
9. Installation