Optional) Setting The Traffic Unit For A Radius Server; Optional) Setting Retransmission Parameters On A Radius Server - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Security
When the RADIUS server does not accept the user name that contains the domain name, you
can run the undo radius-server user-name domain-included command to delete the domain
name before sending it to the RADIUS server.
----End

1.4.8 (Optional) Setting the Traffic Unit for a RADIUS Server

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
radius-server template template-name
The RADIUS server template view is displayed.
Step 3 Run:
radius-server traffic-unit { byte | kbyte | mbyte | gbyte }
The traffic unit is set for a RADIUS server.
By default, the traffic is expressed in bytes on the S9300.
----End
1.4.9 (Optional) Setting Retransmission Parameters on a RADIUS
Server
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
radius-server template template-name
The RADIUS server template view is displayed.
Step 3 Run:
radius-server timeout seconds
The timeout interval for a RADIUS server to send response packets is set.
By default, the timeout interval for a RADIUS server to send response packets is five seconds.
To check whether a RADIUS server is available, the S9300 periodically sends request packets
to the RADIUS server. If no response is received from the RADIUS server within the timeout
interval, the S9300 retransmits the request packets.
Step 4 Run:
Issue 06 (2010–01–08) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 AAA and User Management Configuration
1-15