Statically Configuring An Rp; Configuring An Msdp Peer; Huawei Proprietary And Confidential - Huawei Quidway s3700 series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Multicast
An interface is configured as a C-RP.
----End

8.4.4 Statically Configuring an RP

To configure a static RP, you need to configure the addresses of the loopback interfaces as the
RP addresses on all the devices in a PIM-SM domain.
Context
Do as follows on all switchs in the PIM-SM domain:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
pim
The PIM view is displayed.
Step 3 Run:
static-rp rp-address
The loopback interface address is configured as a static RP address.
----End

8.4.5 Configuring an MSDP Peer

MSDP peer relationships need be set up between RPs. If there are more than three devices,
MSDP peer relationships should be set up between any two devices and all MSDP peers should
be added to one mesh group.
Context
Do as follows on multiple switchs on which an anycast RP is to be created:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Issue 01 (2011-10-26)
NOTE
l When the PIM-SM network uses a BSR-RP, the configuration is not necessary.
l When the PIM-SM network uses a static RP, the configuration is mandatory.
NOTE
If the number of switchs configured with the RPs that have the same IP address exceeds two, ensure the
interconnection between the switchs that set up MSDP peer relationship.

Huawei Proprietary and Confidential

Copyright © Huawei Technologies Co., Ltd.
8 MSDP Configuration
203