Igmp-Snooping Router-Aging-Time; Igmp-Snooping Special-Query Source - H3C s3100 series Command Manual

Related commands: igmp-snooping, igmp-snooping querier, igmp-snooping general-query
source-ip
Examples
# Configure the IGMP query interval to 100 seconds in VLAN 3.
<Sysname> system-view
System view, return to user view with Ctrl+Z.
[Sysname] igmp-snooping enable
[Sysname] vlan 3
[Sysname-vlan3] igmp-snooping enable
[Sysname-vlan3] igmp-snooping querier
[Sysname-vlan3] igmp-snooping query-interval 100

igmp-snooping router-aging-time

Syntax
igmp-snooping router-aging-time seconds
undo igmp-snooping router-aging-time
View
System view
Parameters
seconds: Aging time of router ports, in the range of 1 to 1,000, in seconds.
Description
Use the igmp-snooping router-aging-time command to configure the aging time of router ports.
Use the undo igmp-snooping router-aging-time command to restore the default aging time.
By default, the aging time of router ports is 105 seconds.
The aging time of router ports should be about 2.5 times the IGMP query interval.
Related commands: igmp-snooping.
Examples
# Set the aging time of the router port to 500 seconds.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] igmp-snooping router-aging-time 500
igmp-snooping special-query source-ip
Syntax
igmp-snooping special-query source-ip { current-interface | ip-address }
undo igmp-snooping special-query source-ip
1-13