Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 992

SRS –
Air Bag Module and Seat Belt Pre-tensioner Disposal Procedures
Wires
Tyres without wheels
Wires
Air bag module
Deployment wire
4. Set the air bag modules as follows:
Air bag module
<Air bag module (driver's side)>
(1) Take the SRS air bag adapter harness B that is
connected to the wires, pass it beneath the old tyre
wheel assembly, and connect it to the air bag module.
(2) Pass the thick wire through the air bag module
mounting hole, and then secure the air bag module
to an old tyre with a wheel in it so that the pad on
the module is facing upwards.
Caution
Leave some space below the wheel for the adaptor
harness. If there is no space, the reaction when
the air bag deploys could damage the adaptor
harness.
(3) Place three old tyres without wheels on top of the
tyre secured to the air bag module.
<Air bag module (front passenger's side)>
(1) Connect the deployment wires to the SRS air bag
adaptor harness A, pass it beneath the tyre, and wheel
assembly, and connect it to the air bag module.
(2) Pass thick wires into the hole of the air bag module
bracket, and secure them to the wheel of the old tyre
with wheel (4 locations), with the air bag deployment
surface facing upwards.
Caution
a) Leave some space below the wheel for the
deployment wires.
If there is no space, the reaction of the air
bag deployment could result in damage of the
adaptor harness.
b) While deployment takes place, do not have
the connector of the SRS air bag adaptor
harness A inserted between the tyres.
52B-43