Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 993

52B-44
SRS –
Tyres without wheels
Deployment wire
SRS air bag
adapter harness A
MB686560
Seat belt pre-tensioner
Wir
e
Tyres without wheels
Air Bag Module and Seat Belt Pre-tensioner Disposal Procedures
Seat back
assembly
Wir
e
SRS air bag
adapter
harness A
MB686560
(3) Place three old tyres, without wheels, on top of the
tyre secured to the air bag module, and secure all
tyres with ropes (4 locations).
<Side air bag module>
(1) Place the seat back assembly so that the rear of the
assembly is lying on the ground.
(2) Connect SRS air bag adapter harness A (Which is
connected to the deployment harness) to the side
air bag module connector.
<Seat belt pre-tensioner>
(1) Connect SRS air bag adapter harness A (with the
deployment harness connected) to the seat belt
pre-tensioner from the top of the old tyre with the
wheel in it.
(2) Pass the wires through the hole on the seat belt
retractor bracket and secure them to the front (raised
part) of the wheel on two places.
Caution
a) The deployment harness should be left with
some slack. If it is too tight, the adapter harness
may become damaged during deployment.
b) The connector of the SRS air bag adapter
harness A should be placed so that it is not
clamped by the tyres during deployment or
operation.
c) Pull the seat belt out the outside of the tyre,
and then place one tyre without a wheel inside
on top of the existing tyre.
NOTE
The cylinder of the seat belt pre-tensioner should be
placed inside the cavity of top tyre.