Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 991

52B-42
SRS –
<Air bag module (driver's side)>
Two wires
SRS air bag
adapter harness B
MR203491 or
MB628919
Insulation tape
<Air bag module (front passenger's side)
and side air bag module>
Two wires
SRS air bag
adapter harness A
MB686560
Insulation tape
Air Bag Module and Seat Belt Pre-tensioner Disposal Procedures
Deployment Outside The Vehicle
Caution
1. This should be carried out in a wide, flat area at least
2. Do not perform deployment outside, if a strong wind
1. Disconnect the negative (–) and positive (+) battery cables
2. Remove the air bag modules (driver's side and front
3. Connect two wires, each six meters or longer, to the two
Connection
6 m
long or
more
Connection
6 m long or more
6 m away from obstacles and other people.
is blowing, and if there is even a slight breeze, the
air bag module should be placed and deployed
downwind from the battery.
from the battery terminals, and then remove the battery
from the vehicle.
Caution
Wait at least 60 seconds after disconnecting the battery
cables before doing any further work. (Refer to
P.52B-4.).
passenger's side) (Refer to P.52B-30, 31.) and the front
seat back assemblies with built-in side air bag module
from the vehicle. (Refer to GROUP 52A – Front Seat.)
Caution
The air bag module should be stored on a flat surface
and placed so that the air bag deployment surfaces
are facing upward. Do not place anything on top of
them.
leads of SRS air bag adapter harness B <air bag module
(driver's side)> or SRS air bag adapter harness A <air
bag module (front passenger's side) and side air bag
module>, and cover the connections with insulation tape.
The other ends of the two wires should be connected
to each other (short-circuited), to prevent sudden
unexpected deployment of the air bag module.