Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 994

SRS –
Air Bag Module and Seat Belt Pre-tensioner Disposal Procedures
Wires
Vehicle battery
5. At a location as far away from the air bag module or
seat belt pre-tensioner as possible, and from a shielded
position, disconnect the two connected wires from each
other and connect them to the two terminals of the battery
(which has been removed from the vehicle) to deploy the
air bag or to operate the seat belt pre-tensioner.
Caution
(1) Before deployment, check carefully to be sure that
no one is nearby.
(2) The inflator will be quite hot immediately following
deployment, so wait at least 30 minutes to allow
it to cool before attempting to handle it. Although
the gas resulting from air bag deployment is not
poisonous, it should not be inhaled. Refer to the
Deployed Air Bag Module or Operated Seat Belt
Pre-tensioner Disposal Procedures (P.52B-46) for
post-deployment handling instructions.
(3) If the air bag fails to deploy or seat belt
pre-tensioner fails to operate when the procedures
above are followed, do not go near the module
or the seat belt pre-tensioner. Contact your local
distributor.
6. After deployment or operation, dispose of the driver's side
air bag module, front passenger's side air bag module
or seat belt pre-tensioner according to the Deployed Air
Bag Module and Seat Belt Pre-tensioner Disposal
Procedures. (Refer to P.52B-46.)
7. After deployment or operation, remove the side air bag
module from the seatback and then dispose it according
to the Deployed Air Bag Module and Seat Belt
Pre-tensioner Disposal Procedures. (Refer to P.52B-46.)
52B-45