Table of Contents
Advertisement
12.5.1
Multiprocessor Serial Data Transmission
Figure 12.11 shows a sample flowchart for multiprocessor serial data transmission. For an ID
transmission cycle, set the MPBT bit in SSR to 1 before transmission. For a data transmission
cycle, clear the MPBT bit in SSR to 0 before transmission. All other SCI operations are the same
as those in asynchronous mode.
Read TDRE flag in SSR
Write transmit data to TDR and
set MPBT bit in SSR
Clear TDRE flag to 0
All data transmitted?
Read TEND flag in SSR
Clear DR to 0 and set DDR to 1
Clear TE bit in SCR to 0
Figure 12.11 Sample Multiprocessor Serial Transmission Flowchart
Rev. 1.00, 05/04, page 260 of 544
Initialization
Start transmission
TDRE = 1
Yes
Yes
TEND = 1
Yes
Break output?
Yes
<End>
[1] SCI initialization:
[1]
The TxD pin is automatically
designated as the transmit data
output pin.
After the TE bit is set to 1, a
[2]
frame of 1s is output, and
transmission is enabled.
No
[2] SCI status check and transmit
data write:
Read SSR and check that the
TDRE flag is set to 1, then write
transmit data to TDR. Set the
MPBT bit in SSR to 0 or 1.
Finally, clear the TDRE flag to 0.
[3] Serial transmission continuation
procedure:
To continue serial transmission,
be sure to read 1 from the TDRE
No
[3]
flag to confirm that writing is
possible, then write data to TDR,
and then clear the TDRE flag to 0.
[4] Break output at the end of serial
transmission:
To output a break in serial
transmission, set port DDR to 1,
No
clear DR to 0, and then clear the
TE bit in SCR to 0.
No
[4]
Advertisement
Table of Contents
