Table of Contents
Advertisement
Section 11 Watchdog Timer (WDT)
This LSI incorporates two watchdog timer channels (WDT_0 and WDT_1). The watchdog timer
can generate an internal reset signal or an internal NMI interrupt signal if a system crash prevents
the CPU from writing to the timer counter, thus allowing it to overflow. Simultaneously, it can
output an overflow signal (RESO) externally.
When this watchdog function is not needed, the WDT can be used as an interval timer. In interval
timer operation, an interval timer interrupt is generated each time the counter overflows. A block
diagram of the WDT_0 and WDT_1 is shown in figure 11.1.
11.1
Features
• Selectable from eight (WDT_0) or 16 (WDT_1) counter input clocks.
• Switchable between watchdog timer mode and interval timer mode
Watchdog Timer Mode:
• If the counter overflows, an internal reset or an internal NMI interrupt is generated.
• When the LSI is selected to be internally reset at counter overflow, a low level signal is output
from the RESO pin if the counter overflows.
Internal Timer Mode:
• If the counter overflows, an internal timer interrupt (WOVI) is generated.
Rev. 1.00, 05/04, page 221 of 544
WDT0102A_020020040200
Advertisement
Table of Contents
