D-Link DXS-3600 Series Cli Reference Manual page 286

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Example
This example shows how to configure a maintenance association MIP creation to "auto".
Switch# configure terminal
Switch(config)# cfm domain op-domain level 2
Switch(config-cfm-md)# cfm ma name op-ma1 vlan 2
Switch(config-cfm-ma)#
Switch(config-cfm-ma)#
15-21 mep enable
This command is used to enable the MEP state. To disable the MEP state, use the no command.
mep enable
no mep enable
Parameters
None.
Default
By default, this option is disabled.
Command Mode
CFM MEP Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to enable and disable MEP state.
Example
This example shows how to enable the MEP state.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# cfm mep mepid 1 ma name op1 domain op-domain
Switch(config-cfm-mep)# mep enable
Switch(config-cfm-mep)#
15-22 pdu-priority
This command is used to define the 802.1p priority that is set in the CCM and the LTM messages
transmitted by the MEP. Use the no form of the command to reset to the default setting.
pdu-priority COS-VALUE
no pdu-priority
mip creation auto
281