D-Link DXS-3600 Series Cli Reference Manual page 241

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Command Mode
EXEC Mode or any configuration.
Command Default Level
Level: 1.
Usage Guideline
Use this command to check the route redistribution configuration about BGP. If no option is specified for
the command, the route redistribution information for IPv4 unicast address family is displayed.
Example
This example shows how to check the route redistribution configuration about BGP.
Switch# show ip bgp redistribute
Route Redistribution Settings
Source
Protocol
--------
LOCAL
Total Entries : 1
Switch#show ip bgp vpnv4 vrf VPN-A redistribute
Route Redistribution Settings (For VRF VPN-A)
Source
Protocol
--------
LOCAL
Total Entries : 1
Switch#
11-93 show ip bgp reflection
This command is used to display the route reflection configuration of BGP.
show ip bgp [ipv4 unicast | vpnv4 unicast] reflection
Parameters
ipv4 unicast
vpnv4 unicast
Default
Destination Type Metric
Protocol
------------ ---- ------
BGP All 0
Destination Type Metric
Protocol
------------ ---- ------
BGP All 0
(Optional) Specifies to display reflection information of the IPv4
address family.
(Optional) Specifies to display reflection information of the VPNv4
address family.
RouteMapName
------------
N/A
RouteMapName
------------
N/A
236