D-Link DXS-3600 Series Cli Reference Manual page 275

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
cfm enable
no cfm enable
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to enable or disable the CFM function on the specified physical interface.
Example
This example shows how to enable the CFM function on the specified physical interface.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# cfm enable
Switch(config-if)#
15-8 cfm lck start
This command is used to start the CFM management lock action. To stop the CFM management lock
action, use the cfm lck stop command.
cfm lck start mepid MEP-ID ma name MA-NAME domain DOMAIN-NAME
cfm lck stop mepid MEP-ID ma name MA-NAME domain DOMAIN-NAME
Parameters
mepid MEP-ID
name MA-NAME
domain DOMAIN-NAME
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 12.
Specifies the MEP ID.
Specifies the MA name as the identifier.
Specifies the MD name as the identifier. It is a string type of maximum
length 22.
270