D-Link DXS-3600 Series Cli Reference Manual page 295

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Command Default Level
Level: 1.
Usage Guideline
This command is used to display the MEPs that have configurations.
Example
This example shows how to display the MEPs that have configurations.
Switch# show cfm mepid 1 ma name op-ma domain op-domain
MEPID: 2
Port: eth1/0/9
Direction: Up
CFM Port Status: Enabled
MAC Address: 00-09-5A-B9-AC-18
MEP State: Enabled
CCM State: Enabled
PDU Priority: 7
Fault Alarm: Disabled
Alarm Time: 250 centiseconds
Alarm Reset Time: 1000 centiseconds
Highest Fault: Some Remote MEP Down
AIS State: Disabled
AIS Period: 1 Second
AIS Client Level: Invalid
AIS Status: Not Detected
LCK State: Disabled
LCK Period: 1 Second
LCK Client Level: Invalid
LCK Status: Not Detected
LCK Action：Stop
Out-of-Sequence CCMs Received: 0
Cross-connect CCMs Received: 0
Error CCMs Received: 0
Port Status CCMs Received: 0
CCMs transmitted: 14813
Out-of-order LBRs Received: 0
Unexpected LTRs Received: 0
AIS PDUs Received: 0
LCK PDUs Received: 0
Switch#
Display Parameters
Highest Fault
Normal CCMs Received: 0
If Status CCMs Received: 0
In-order LBRs Received: 0
Next LTM Trans ID: 0
LBMs Transmitted: 0
AIS PDUs Transmitted: 0
LCK PDUs Transmitted: 0
None: No defect has been present since the last FNG_RESET state.
Some Remote MEP Defect Indication: The last CCM received by this
MEP from some remote MEP indicates that remote MEP detects some
defect.
Some Remote MEP MAC Status Error: The last CCM received by
this MEP indicated that the remote MEP's associated MAC is reporting
an error status.
290