D-Link DXS-3600 Series Cli Reference Manual page 242

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display what have been already configured to the local BGP about the route
reflection.
Example
This example shows how to display what have been already configured to the local BGP about the route
reflection.
Switch# show ip bgp reflection
Client to Client Reflection State : Disabled
Cluster ID
Route Reflector Client
peer group: inter (172.18.10.1)
172.18.10.3
172.18.10.4
172.18.10.5
Switch#
11-94 show ip bgp summary
This command is used to display BGP summary information.
show ip bgp [ipv4 unicast | vpnv4 {all | rd RD-VALUE | vrf VRF-NAME}] summary
Parameters
ipv4
unicast
vrf VRF-NAME
vpnv4
all
rd RD-VALUE
Default
None.
: 0.0.0.0
:
(Optional) Specifies the IPv4 address family. The type of address
family determines the routing table that is displayed.
Specifies to display the unicast address family.
(Optional) Specifies the VRF family. The type of address family
determines the routing table that is displayed.
(Optional) Specifies the IPv4 VRF family. The type of address family
determines the routing table that is displayed.
(Optional) Specifies to display summary information for all the VPNv4
address family.
(Optional) Specifies to display summary information associated with
the RD.
237