D-Link DXS-3600 Series Cli Reference Manual page 299

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
This example shows how to display all the remote MEP information seen by local MEP 1.
Switch# show cfm remote-mep mepid 1 ma name op-ma domain op-domain
Remote MEPID: 2
MAC Address: 00-11-22-33-44-02
Status: OK
Port State: Up
Last CCM Serial Number: 1000
Sender Chassis ID: None
Sender Management Address: 10.90.90.90:161
Detect Time: 2013-11-01 17:00:00
Remote MEPID: 3
MAC Address: 11-22-33-44-02-05
Status: OK
Port State: Up
Last CCM Serial Number: 200
Sender Chassis ID: None
Sender Management Address: 10.90.90.90:161
Detect Time: 2013-11-01 17:00:00
Switch#
This example shows how to display the remote MEP information.
Switch# show cfm remote-mep mepid 1 ma name op-ma domain op-domain remote-mepid 2
Remote MEPID: 2
MAC Address: 00-11-22-33-44-02
Status: OK
Port State: Up
Last CCM Serial Number: 1000
Sender Chassis ID: None
Sender Management Address: 10.90.90.90:161
Detect Time: 2013-11-01 17:00:00
Switch#
Display Parameters
Status
RDI
Port State
RDI: Yes
Interface Status: No
RDI: Yes
Interface Status: No
RDI: Yes
Interface Status: No
Idle: The momentary state during reset.
Start: The timer has not expired since the state machine was reset,
and no valid. The CCM has yet been received.
Failed: The timer has expired, both since the state machine was reset,
and since a valid CCM was received.
OK: The timer has not expired since a valid CCM was received.
Yes: Indicates the state of the RDI bit in the last received CCM.
No: If none has been received.
The port state indicates the ability of the bridge port on which the
transmitting MEP resides to pass ordinary data, regardless of the
status of the MAC.
None: Indicates either that no CCM has been received or that no port
294