D-Link DXS-3600 Series Cli Reference Manual page 283

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Parameters
period PERIOD
level LEVEL
Default
By default, this option is disabled.
The default period is 1 second.
Command Mode
CFM MEP Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to configure the parameters of the LCK function on a MEP. If no parameter is
specified, it will enable the CFM LCK function. If the client level is not designated, it will equal the
maintenance domain level that the most immediate client layer MIPs and MEPs exist on. This default
client maintenance domain level is not a fixed value. It may change when creating or deleting higher level
maintenance domain and MA on the device.
When the most immediate client layer MIPs and MEPs do not exist, the default client maintenance
domain level cannot be calculated. If the default client maintenance domain level cannot be calculated
and the user does not designate a client level, the LCK PDU cannot be transmitted.
Example
This example shows how to configure the LCK function so that it has a client level of 5.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# cfm mep mepid 1 ma name op1 domain op-domain
Switch(config-cfm-mep)# lck level 5
15-18 mepid-list
This command is used to create an MEP ID list.
mepid-list {add | delete} MEPID-LIST
Parameters
mepid-list MEPID-LIST
Default
None.
Command Mode
(Optional) Specifies the transmitting interval of the LCK PDU. It can be
1sec or 1min.The default period is 1 second.
(Optional) Specifies the client level to which the MEP sends the LCK
PDU. The range is from 0 to 7.
Specifies the MEP IDs contained in the MA. The range of the MEPID is
from 1 to 8191.
278